2 Heads 58 Feeders CHMT48VB Benchtop SMD Pick and Place Robot All in one Chip Mounter

1. Convenient software, Embedded Linux System of the machine, very stable industry main board, independent operation, no need external computer, operation more easy and convenient.
2. Top and bottom two cameras CCD system correct the position of each components very accurate, especially for IC (max 22*22mm).
3. Machine support all different kinds of components, from 0402, 0603- QFN, as well as cut tape, tube IC, or bulk IC. Machine can place multi kinds of PCB.
4. It has flexible PCB clamping fixture, and it has custom IC tray, front bulk IC feeder, very convenient.
5. The vision also can second correction machine origin point, make sure origin point correct.
6. 2 heads/ 4 heads with high precise Juki Nozzles with magnet, no need to disassemble with wrench, nozzles can rotate angle -180 degree~ +180 degree. Placing height is adjustable. 4 serials machine max components height is 5mm and 5 serails machine max height is 10mm.
7. 4 serails machine's pull pin automatically return to avoid nozzles broken, pull pin not be stuck. 5 serial's machine using Yamaha pneumatic feeder auto feeding, more faster speed.
8. Z axis detection, placement head can auto detect the height and angle, auto back to origin to prevent any broke.
9. Closed-loop control, X,Y Axis with encoder, motor never lose steps.
10. PCB calibrate by two vision cameras (machine will auto find 2 points), amend the offset of PCB. Only calirbate 2 points, rest components will auto correction, calibration can be rapidly and accurately for PCB, do not need to care about offset, no need to calculate the input.
11. Comes with vacuum detection, if one component suck crooked, it will automatically throw it to the feed zone, then pick a new one to mount again.
12. Comes with vision detection, camera will auto correct component angle and place onto PCB board in right place. If heads not picking up components, camera will detect it and go back to pick again, 3 times not picking, machine will alarm and stop.
13. If lack material it will automatic detection, then alarm; after supply material, then continue working, no need to re-start.
14. Support any number of PCB batch.
15. If no PCB file, or don’t use software load out work file, you can create a new file to program.
16. Comes with convert tool (PC version), edit work file in computer and load work file into machine by USB port, quick and convenient.
17. Support single step.

Standard Accessories for CHMT48VB:

1) Pick and Place Machine CHMT48VB 1
2) Juki nozzle total 4pcs (503, 504, 505, 506 size)
3) 8G USB driver 1
4) Power Cord 1
5) Pull needle 2
6) Coil for pull pin1
7) Camera positioning adjust black board 1
8) Hex wrench 6
9) Tweezers 1
10) Brush 1
11) Pen for touch screen 1
12) Fixture for IC tray 4
13) Grease 1
14) English user manual 1

Real photos for CHMT48VB:

Left 29 tape feeders + right 29 tape feeders, total 58pcs feeders, support more different kinds of components:

New type updated with square rail, higher accuracy:

Top and Bottom camera, make sure each component place very accurate:

Custom IC tray (software allow 20pcs) cut tape supported:

All motor with encolder, closed-loop contro, not out of steps:

Bulk IC tray suppoted:

 
Customer's picture: